...
Add the following code to your config/eazybi.toml file:
Code Block [[regular_jobs]] job = "Geocoding.perform" every = "24h"
Specify a new regular job Geocoding.perform and the frequency for execution of this job. In the code example below, a frequency of 24h is set. You can specify a value that corresponds to your needs.
Add the following code to the [general] section of your config/eazybi.toml file:
Code Block tomtom_api_key = "<your_tomtom_api_key>" tomtom_base_URL = "api.tomtom.com" tomtom_version_number = "2"
In the code block above, you have to replace <your_tomtom_api_key> with your actual TomTom API key. Also you have to check if the defined version is the current version of the API.Define the following plan parameters in the Update Account section's Plan parameters box of your flex.bi account:
Code Block enable_geocoding = true min_address_precision = 8 min_address_similarity = 0.85
You can also use the following plan parameter, to enable debugging mode and log geocoding errors:
Code Block debug_geocoding = "error"
- min_address_precision is the minimum geocoding result precision that is required to save the latitude and longitude values. The default value is 8, but you can increase it, to make the rules for result acceptance more strict, or decrease it, to make the rules less strict. The precision is a value returned by the TomTom service together withe the geocoding results, which specifies how precise are the returned results based on the TomTom algorithm.
- min_address_similarity is the minimum similarity between the original address and the address returned from the geocoding service. The default value is 0.85, but you can increase it, to make the similarity rules more strict, or decrease it, to make the rules less strict. The similarity is a value calculated by comparing the address saved in flex.bi and the results returned from the TomTom geocoding service.
...
By hovering over a point on map, you can see selected measures for the location.
| Anchor | ||||
|---|---|---|---|---|
|